Couple questions. First, what are you measuring voltage with? Cheap digital meters will often give erroneous readings when used with engines having point type ignitions & copper plug wires due to noise pickup on the leads. The fact that it reads correctly on another engine with an alternator doesn't guarantee it'll read correctly on the one you're concerned about. A good analog voltmeter is a very useful tool for working on these old systems.
Second, if the generator is in fact putting out 15+ volts, the regulator probably needs to be adjusted. The fact that its new doesn't mean it was adjusted correctly, particularly if it came from China. Newer electromechanical regulators have three coils; a voltage relay, an overcurrent relay, and a cutout relay to disconnect the battery when the generator's not turning.
Voltage is adjusted by changing the spring tension on the voltage relay...less spring tension gives lower voltage. Voltage regulation is accomplished by this relay switching a resistor in & out of the field line to control field current.
However, before tinkering with the regulator, I'd make sure that the measured voltage is in fact correct.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.