Posted by doug in illinois on November 27, 2009 at 17:10:01 from (74.206.45.133):
It has been a while since I asked any questions, but here is one for those of you who either own a newer mobile home or work on them.
We are considering purchasing a 32x70 Southern, zone 3 insulated with 6 inch walls to replace our old 14x70 that will be lucky to make it through the winter. Price is right, it is a 2009 display model.
The price we have negotiated does NOT include the outside A/C unit, and will have an independent hauler deliver and set up. His fees are $6250 to haul it 295 miles, set, level, vinyl, hook all the crossovers, roof cap. We will skirt, stretch the carpet at the marriage, hook up water, sewer, power.
But, back to main question, I am scared of the electric furnace. We are used to our propane furnace. I am worried the electric furnace is going to be EXPENSIVE to run. Our power costs about $185.00 for around 1050 KW or so. So in other words, about 18 cents KW/hour instead of the so called 8 cents before they get done adding "facility charge, line maintainance charge, depreciation charge, equipment maintainance charge, etc".
It will cost us more to install a true heat pump, either air or ground source than just a cheap A/C. The electric furnace CLAIMS to be 100 percent efficient, BUT??
The new 32x70 does have a fireplace. Could burn wood, but would I be better off to convert it to gas?
Have also thought about getting an outside wood furnace. If so, I think the fireplace would be better as gas, need to have some way to keep it warm WHEN the power goes off again this winter. My generator can't begin to pull the electric furnace, I think I can get more heat from the fireplace as gas than I can from wood without the fire danger. DOUG
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
