Posted by JOB on November 27, 2009 at 14:47:02 from (74.36.130.59):
In Reply to: Wayne wood chipper posted by mdjd4020 on November 26, 2009 at 21:05:44:
Try it out first, I would doubt it will chip anything over six inches if that. After the chipper has been brought up to speed and the drum spinning disengage the clutch and shut off the engine. You will be able to hear any growling in the drum bearings if there is any. I replaced the drum bearings in an Asplundh chipper, not a real tough job. Twenty years ago the bearings were $120.00 each from the dealer. 35 hundred I would say is on the high end on price. Those Mobark style chippers put the Asplundh style ones out of business. Get a manual with it so you can adjust the cutter bar clearance. They chip better if set up correctly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.