Tractor Talk Discussion Board |
Re: Honing cylinders
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Shopguy on January 31, 2001 at 04:39:19 from (209.226.118.111):
In Reply to: Honing cylinders posted by Howard on January 31, 2001 at 04:24:29:
Hi Howard With new rings make sure the top of the bore has been ridge reamed.it,s best to hone in place with all components removed,grit and bearings don't mix.flood with varsol during honing.If you do pull the sleeves use new o rings and orient the sleeve as it came out.Read the advice the other guys throw at you and you should get the info you need.Also check your end gap lotsa luck Al
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|