Tractor Talk Discussion Board |
Re: Belt power again
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by IaGuy on January 30, 2001 at 18:03:53 from (24.149.14.30):
In Reply to: Belt power again posted by Bart on January 30, 2001 at 13:00:03:
Modern rubber belts give good service and traction. Stay away from modern pvc belts...very strong, low stretch, but that characteristic is less tolerant to conforming to the pulley crown. Each pulley must have a larger diameter in the center or the belt will inexplicably wander or throw off. two ply rubber with covers not too thick (conveyors and belt elevators aka"legs" have thick covers to resist abrasion and heat. Don't need that, keep em thin enough to get around your pulleys. belt should an inch or two narrower than the narrowest pulley. Use "clipper typ lacing with nylon pin. dont use large plate type lacing...too much shock when it goes around small pulleys. Cadillac lacing...vulcanized endless. My 3 cents good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|