Tractor Talk Discussion Board |
Re: Cylinder liners
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fred OH on January 30, 2001 at 10:27:14 from (208.32.116.37):
In Reply to: Cylinder liners posted by Howard on January 29, 2001 at 07:59:53:
The proper way to remove liners is with a hollow ram cylinder attached to a porta power with a plate machined at the bottom as described earlier. I use a piece of 3/4" all thread with mine and a piece of pipe machined square on the ends and as long as the liner. Then a plate on top of the pipe to set the ram on. The all thread runs through the whole contraption with a nut on each end. Then its just a matter of pumping the ram. These foreign manufacturers that make the ten ton porta power units don't know it but they could sell a lot more of their kits if the hollow cylinders were included in their kits for pulling with. You reckon they read these posts? We'll know if we see it for sale next spring. L8R----Fred OH
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|