Posted by jdemaris on November 23, 2009 at 18:19:34 from (67.142.130.14):
In Reply to: 71 Economy power king posted by Lee09 on November 23, 2009 at 16:15:32:
No insult intended, but you couldn't have tried all the suggestions or it would be figured out by now. There is nothing unique about that little clutch setup unless something has been swapped. It uses all standard parts and nothing made by Power King. Theres a flywheel, disk, pressure plate, and probably a three-speed Crosley car transmission. Did you check with the trans removed to make sure the disk turns free when you push down on the pressure plate fingers? Did you check to make sure the transmission input shaft turns freely in the pilot hole at the end of the crankshaft? Did you check to make sure the throwout bearing pushings down the pressure plate fingers far enough via the foot pedal?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.