Posted by jdemaris on November 15, 2009 at 09:59:42 from (67.142.130.11):
This is the last follow up to my Deere 1010 crawler that I ran for many years with a 6 cylinder distributor with a four-cylinder cap stuck on it (1010 is a four cylinder engine).
I put the distrutor back on today with the four-cylinder points-cam stuck in. It runs better then ever, since I've owned it. Engine basically sounds the same but seems to have maybe 20% more power. I can charge a dirt-bank now in 2nd gear and lift with a full bucket of hard-pan and rock. Before this, I could just barely do that in 1st gear.
So, if somebody ever asks you a stupid question - like "can a 6 cylinder distributor run a 4 cylinder engine" - the answer is "yes."
I did the math and it seems this is how it ran. When it had the 6 cylinder distributor on it, and I timed it with a timing light hooked to #1 cylinder, it resulted in this. Firing order is 1-3-4-2. Timing spec is 26 degrees before TDC at full RPM. So, #1 was firing at 26 degrees BTDC, #3 was firing at 56 degrees BTDC (30 degrees overadvanced), #4 was firing properly at 26 degrees BTDC, and #2 was firing at 56 degrees BTDC (30 degrees over advanced).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.