Posted by mEl on October 29, 2009 at 14:01:36 from (71.241.110.174):
In Reply to: Pertronix Ignitor posted by Mark Warden on October 29, 2009 at 11:41:16:
Read the directions carefully that come with the Pertronics unit. They are sensitive to the ohms of the coil, a coil with low ohms causes a high switching current that can damage the module. If you are unsure of the coil ohms,, take an ohmmeter, disconnect one of the terminals from the coil and read the meter with the meter leads across both terminals, there should be about 3-4 ohms reading or in that area. Generally if a resistor is used in the original circuit it is a low ohms coil-about 1.5 or in that area and the resistor must be retained or a coil with the proper ohms substituted, personally I would invest in the coil that is recommended for that unit, it will have the proper ohms to protectr the module and will have a higher secondary voltage output. Once installed and running do not remove a spark plug wire to check spark as spark can jump down the coil tower to the Pertronics connections and damage the module. Experience speaking. mEl
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.