Re: Are John Deere Motors Harder To Get Unstuck?

Posted by John T on October 28, 2009 at 12:48:09 from (66.244.97.31):

In Reply to: Are John Deere Motors Harder To Get Unstuck? posted by Tom Krotzman on October 28, 2009 at 12:15:56:

If they are harder to "un stick" it may be due to the fact THEY HAVE HUGE PISTONS AND BIG BORES and a lot of mass and surface area for things to rust n sieze together....In cases where they arent stuck too bad one might fill n soak n drain the cylinders with a witches brew of auto tranny fluid and diesel and brake fluid and remove the rocker arm shaft to avoid bending pushrods from stuck valves and get her rocking back n forth a little at a time to free it BUTTTTTTTTTTTTTTTTT

If its stuck too bad the cylinders can be messed up and/or rings broken and siezed and to be fixed right she needs tore down. On the Deeres that means removing the rod caps and pulling the whole block out forward with pistons intact n then drive them out n fix any cylinder damage etc. its not any cheap or easy run

Good Luck with her

John T

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Optional Video Title: Optional Video URL: Advanced Posting Options Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.   Advanced Posting Tools   Upload Photo  Select Gallery Photo  Attach Serial # List  Return to Post

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]