Posted by pete 23 on October 25, 2009 at 18:16:18 from (173.87.147.73):
In Reply to: IH 5288 wont move posted by Chris22 on October 25, 2009 at 17:00:19:
If this only happens upon start up , it is likely switch or connections on switch on the clutch pedal. Also, pressure has to build on start up before sentry will allow clutches to engage so if you are too fast on the clutch and throwing it in gear upon start up this can happen. I have seen several operators do this. If pto is only slow at the same time tractor won't move, then you probably have a reglated pressure problem, other wise, if pto is always slow to engage that would be a problem specific to the pto rear unit itself. Now, if tractor stop moving while driving, and sentry light comes on it is most likely the high or low clutch pack pressure switch's or sentry it self. Intermittent problems on these tractors can be hard to trace down sometimes. IH has a couple of good trouble shooting charts, one electrical and one hydraulic, and procedures to follow but it requires some one familiar with the process.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
