Lou, I've done that, left the other half up. In the hedgerow across the road, where our property butts up to the neighbors, the trees provide a nice privacy wall. Really healthy maple, split at the crotch one year, got that piece cut up, then another 1/3 split off, but after that, there was nothing else that would come down, completely healthy tree. I cut vertically up/down, to the partial stump and cut that at an angle to help the water run off. This maple was a thin/tight bark type, good sap too, never been tapped but was cut in late winter, I did boil up some syrup from it. I'm not sure if the tree paint that can be used where you trim limbs would help, usually rot and decay and or ants are what weaken these and black cherry, though the latter will hold on right till the end. This maple just outgrew it's ability to hold it's own weight, I see 2 more of the same genetics, looks like one could cinch a cable or a few around the weak area to prevent the split from getting bigger. Luckily, all are in places where there is nothing nearby, realizing that in some situations, no other choice but to take it down. Been a few years and the exposed area is still hard, weathered but no signs of insects or decay, remainder of the tree top is full of leaves and maintains the continuous sight line of trees, kind of glad I did it that way, hard to say what will eventually happen though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.