You've been getting mixed answers from people and then you come here. Good luck.
What size and weight bales? How many and how often do you plan to move them? Have you thought about a bale trailer or a pickup bed attachment?
There is more to it than horsepower. The load and weight rating for tractor front end. Hydraulic gpm and psi output. There is loader size and load lift rating. The highest rated loader won't do you a bit of good if the bales pulls your back tires off the ground. No tricycle front wheels. Are you going to use a 3 point rear fork?
I had a 460 with a manure bucket. Wouldn't hardly pick up the 1500# bales they make around here. Best I could do sometimes is get the bucket under it, wrap a chain around it, and then back around. I've pulled them into the corral with my pickup too.
The best loader tractor is a skid steer provided it has the lift capacity for your size bales. Can't plow with it. Look for a 560 or bigger tractor with the right loader.
Then you have to consider that what may work when it is warm and dry may just get buried to its axles in the corral come winter and muddy ground. For winter hay moving, you better get a gasser unless you live in Florida cause you will spend all your spare time trying to start it and warm it up.
Where do you get your hay? The guy that bales our field can do any size we want, 700# to 1500#. Now that I have a 2606 industrial with an IH 3000 loader than can toy around with those big bales, I just want the big ones now. I've had occasion to bury it in a muddy corral moving those bigguns. Then it sits until a hard freeze.
As an emergency standby, I line up a few bales at the other gate. It's not easy but 2 of us can wedge between them and start one rolling into the corral. When I set them by the gate, I try to rotate them if they started to flat spot on one side. If the weather may turn bad for a while, I'll line up 3 or 4 bales spaced along the barn and put some horse panels around them. Then move the panels as one is needed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.