Posted by Billy NY on October 07, 2009 at 18:42:27 from (74.67.3.238):
In Reply to: Steel Fencing Question posted by jacksonduper on October 07, 2009 at 16:00:05:
You could also weld a flange/baseplate onto the edge of the pipe, 2"-3" dia pipe, use a square plate say 6"x6" on the bottom, stick weld a continuous weld at the base, pre -drill 4 1/2" diameter fastener holes near each corner before welding make a template if you wish, do as many as you need, mild steel is fine, once welded wire wheel off all the mill scale on new steel, clean with solvent and use cold zinc galv spray, so it won't rust anytime soon and then drill the slab with the template and install pipe with a baseplate fasten with a sleeve anchor, wedge bolt, expansion bolt, ie; Hilti, what have you and it's done.
Other way you could lay out the posts, core drill oversize of the pipe diameter, set, and fill with a high strength grout or similar that will bond strong to the metal and the existing concrete, non shrink type material and obtain the same compressive strength as the concrete, though I think the mechanical fasteners would be stronger and easier, + done as soon as you install those fasteners.
Also, be careful with edge distances, hopefully your posts are not too close to any edge of the slab, either core drilling or using mechanical fasteners.
This post was edited by Billy NY at 18:45:02 10/07/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
