|
Tractor Talk Discussion Board |
Re: Re: Leaking O-ring on Backhoe Control for Case 580SE
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by GEO on January 06, 2001 at 07:29:08 from (63.104.132.106):
In Reply to: Re: Leaking O-ring on Backhoe Control for Case 580SE posted by Got the same problem on a 79 MF TLB (shep) on January 05, 2001 at 20:08:28:
Oring seals are ready available from sereral sources. NAPA auto parts store or most any tractor and industrial parts sources. Simply measure the diameter of the spools that you have and then go to town and inquire about Orings with the same ID as your spool measure OD. Most Orings for hydraulic valve bodies are usually 3/32 or 1/8 cross section in size. Orings are listed in dash sizes. For example, if you have a 7/8 spool the dash number for a Oring with a cross section of 1/8 is 212. If the spool diameter is 1", the dash number will be 214. As for replacing Orings. Some of the Case units will have a screw on spring cover on the bottom of the valve that can be removed and the spools can then slide out the bottom. The Oring on the bottom will probably come out with the spool. The Oring on the top will be in a groove. I would remove the entire valve body from the hoe and not only replace all of the Orings on the spools but would also replace all the Orings and B/Us on the safety valves as well.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
