Tractor Talk Discussion Board |
Re: While on backhoes. . .
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Truck on January 05, 2001 at 21:32:33 from (172.171.134.186):
In Reply to: While on backhoes. . . posted by Shep on January 05, 2001 at 20:12:33:
It depends on whether you can get new pins and bushings in standard sizes to fit the machine. Then it is a case of pressing or sledgehammerring them out, then rigging up something to press the bushings in and slip the pins in. However, if the pins were neglected to the point where the bushing holes are no longer round, welding or line boring will be needed. On my machine, stuff was metric, hard to get if not impossible, and things were well worn. I got quotes starting at $550 to rebush just one set of pin holes on the bucket so I ended up buyiong an old lathe and making my own bushing holders out of steel round stock. I pressed in Timken roller bearing races for a replaceable bushing surface, and installed pins that fit the bearings. The holders were welded into torched out holes in the bucket. Not extremely precision, but it works. What do you mean by OVERTHROW? Is it swinging beyond where you intended? That may be an entirely different problem, depending on how your boom swing is powered. Welcome to the wonderfully expensive world of old backhoe repair.;-)
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|