The right way to adjust brakes on something like that is out tight,back off,hit the pedal a few times,adjust tight again.In other words you might not have been able to adjust them out good enough yet which would mean they have to travel farther than one pump will take them to work.Just adjusting them one time is most always not enough because once you apply the brakes a couple of times they move a little and will be loose again.Chevy can be hard to get all the air out of also.I have cracked a bleeder loose and let fluid drip out slow overnight,fill back up and tighten bleeder the next day and fixed it.Might try and bleed everything again starting from the furthest away line,then to the booster,which has a bleeder on it somewhere,then the front axle.Also if everything is worn,and pads are thin,you might be using all the travel you have before the brakes apply.If drums have been turned or are wore bad that could be the problem.See if there is a ledge where the pads ride that is wore into the drums.You might have to replace the pads to take up enough slack to get good brakes.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.