Tractor Talk Discussion Board |
Re: where and how to add springs to a snow blade for a FEL
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Al on December 23, 2000 at 17:01:29 from (209.226.118.44):
In Reply to: where and how to add springs to a snow blade for a FEL posted by Canadian Cowboy on December 23, 2000 at 15:35:08:
Sorry cowboy,the pin ears are 3x3x1,and to answer your actual question,the springs are there,if not they are simply a couple of coils with threaded rod running through them from the lip(a piece of angle welded on) that is on the back of the blade a few inches below the top lip to the part of the harness that piviots with the blade.A couple of nut and washers and you have tension adjustment.The rod is solid at the harness and floats under spring load at the top of the blade.I hope i have communicated this clearly,because it does work well. Al
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|