Posted by jdemaris on August 29, 2009 at 17:20:38 from (72.171.0.145):
In Reply to: charging magnet posted by teddy52food on August 29, 2009 at 16:56:19:
I don't know anything specifically about the Wico EK mag, but I have charged many magnets in rotary magnetos. I bought all the equipment from an old magneto shop years ago, and have their large charger. For most mags, the magnets get charged when out of the magneto, but that's done mainly for convenience and also to prevent the impulse-dogs from getting magnetized (on the drive coupling).
I assume the EK doesn't have any impulse dogs, so that's not an issue. Main thing is, if you DO recharge the magnet when out, you must put a keeper on it right away, or it will lose that magnetism. A keeper can be just about any type of steel that is laid against the magnet, or around the magnet. When the magnet is installed in the magneto, the armature becomes the keeper.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.