Tractor Talk Discussion Board |
DURABILITY OF MASSEY FERGUSON PLANETARY FINAL DRIVE
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ken McWilliams on December 11, 2000 at 09:40:30 from (38.232.245.127):
I have a M-F 50 industrial tractor (similar to Ag model MF-165)that has the planetary final drive at the end of each axle. In looking at the design, I've seen that the stub holding the axle flange is only about 6 - 8" long. I'm concerned about the centerline of the wheels and whether or not premature failure would result from running with the wheels spaced further outward. The origninal wheels looked to place the centerline of the tire about near the length of of the axle stub and within the space between the positions of of the roller bearings. I installed a backhoe on the tractor which required that I space each rear tire outward about 6 inches from the original position in order to get the swing cylinders between the fenders. Will the planetary assemblies tolerate this over-hung loading from the wheels being further spaced out than original? I've seen some MF-165 - 175 tractors with spin-out wheels so I'm wondering how critical it is to have the tire centers near the center of the axle stub of the planetaries. Your opinions, please. KRM
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|