Posted by glennster on July 27, 2009 at 09:49:44 from (99.131.131.158):
In Reply to: Impact Wrench posted by rustin on July 27, 2009 at 07:25:30:
gpoing to depend on what you are going to do with it and what is your budget. i see you were looking at 1/2 or 3/4 drive impacts. if you are planning on using a lot of 3/4 drive stuff for big bolts, you need a good quality impact. if you are an occasional user and not doing a lot of major mechanical stuff, the cordless impacts like dewalt would be a better choice. the cheapie bargain air impacts dont have a lot of power, use a lot of air and dont last that long. my last 1/2 drive i bought from snap-on. 1000 lbs breakout force in reverse, about 850 ft lbs in forward. one bad impact. you gotta wear hearing protection, about 400 dollars for the gun new. you can check with the tool trucks, snap on, matco, cornwell, mac ect and see if they have any used or rebuilt guns too, save you prolly about 1/2.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.