Posted by 37 chief on July 05, 2009 at 08:37:37 from (70.181.168.186):
In Reply to: Bats in my barn. posted by CHSchmidt on July 04, 2009 at 18:21:03:
You have a real problem getting rid of these bats. I had a bunch of them in my barn also. When they leave they circle inside before they leave, and as they are circling they crap and pee on everything as you probably already know. I tried about everything. I parked one of my tractors in my barn and ran the engine with a pipe connected to the exhaust up into the rafters, this got a few. I tried moth balls. I tried bug bombs, sticky fly tape, greased the wood where I thought they land on. They still were there. One day I saw a bunch of them behind a old flat wind shield from a old car laying on the wall about 10 ft up. I sealed all around the wind shield with rags and put a flexable tube from a small enging into this area. A lot of bats didn't return to mexico that year. I may have broke the cycle, because they haven't been back. I know they eat a lot of bugs, but I hate them. Why don't you try the tractor exhaust. stan
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.