Posted by Lanse on June 29, 2009 at 16:04:12 from (65.89.42.129):
Enjoy :-)
lol. And to everyone else, thanks for reading my last post and helping me with it. We started out with a two useless garden tractors, and if it hadent worked, thats exactially what we would have been left with. No harm, no foul, and mabey even a lesson or two learned. Its all good.
On Ryan - WI and Old Roy's advice and a few other peoples, i figured out the wireing.
I taped some wires toether so the dash was no longer needed, and rigged up the choke and throttle mounts on the side of the "console". It accually looks pretty cool now. I'll modify that hood somehow and paint the whole thing later on in the summer. We're gonna change out the pulleys to make it go faster.
Thanks everyone, Thanks Alot!! :-)
Audio/Video clip:Untitled Audio Video ,
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.