Posted by flying belgian on June 28, 2009 at 19:04:20 from (98.132.233.132):
In Reply to: IH-1466 PTO Problem posted by Walt7777777 on June 28, 2009 at 18:34:43:
Had the same thing happen pulling fert. spredder once with the 706. I tried engage, disengage, engage, disengage about 10 times with no sucess. Thought maybe it was low on trans fluid. Shut it off checked fluid. Right up to full mark. Brother in law stopped and we talked about problem for maybe 10 minutes. Started tractor up to go home and get another tractor to finish. Thought I would try it one more time. PTO started right up that time just as if nothing happened. Been working ever since. And I use the pto alot on that tractor. I bet if you go out in the morning and try it, it will work. Let me know how this turns out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
