Tractor Talk Discussion Board |
Re: Re: Re: Pulled Head no clue why zero compression in 1 Cylinder
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ken McWilliams on October 24, 2000 at 03:54:51 from (38.232.245.127):
In Reply to: Re: Re: Pulled Head no clue why zero compression in 1 Cylinder posted by Rick from Paso on October 23, 2000 at 21:25:31:
Rick, From your earlier post, I thought you had already done a leak-down test. A leak down test is where you put compressed air into a cylinder via the spark plug hole. The fitting can be an old spark plug that has a pipe fitting brazed to it. It is connected to a gauge and shut off valve. The cylinder is pressurized, then the valve is shut off allowing it to be trapped and the pressure is monitored on by the pressure gauge. Some local auto parts supply stores have a fitting for the spark plug for leak down tests. Also, this same fitting is used to pressurize the chamber to replace valve springs without taking off the head. You may not be able to find a fitting, because the CASE G-148 uses an unusually large spark plug thread. If you are not getting very much compression, put some ( about 2 tablespoons) heavy weight oil (140 weight gear lube)in the spark plug hole and run a compression test again. If it is higher the rings are probably bad. I rebuilt my CASE G-148 about 2 years ago. It was an easy engine to work on. Do it right and get a complete kit with sleeves. Re-ringing with a taper in the cylinder wall won't last long. Mine is a CASE-O-MATIC. It's difficult to seal between the oil pan and torque tube. I had to do it twice to get it right. Also, the nose of the starter is in transmission fluid, so it had to be adequately gasketed. Good luck, Ken McWilliams Dayton, OH
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|