Posted by Old Ford Mechanic on June 22, 2009 at 10:10:17 from (75.254.4.202):
In Reply to: OT/problem with truck posted by Derrick Gross on June 21, 2009 at 20:14:37:
Kyplowboy has your answer.The oil return holes are plugged in the cylinder heads.The engine is gummed with oil deposits.If you remove the valve covers you will see the problem.It will look like black mud under the covers.Dig all you can out with a screwdriver and a narrow putty knife.Reinstall the covers and go get a couple of quarts of Rislone from your Auto Parts store.Go ahead and pour 1 qt. in the engine now.Start it and let it warm up and then drive it a few miles while watching your oil guage.It should show good pressure now.The Rislone is cutting the deposits loose now as the engine runs.Drive it only a few miles then drain all the oil and Rislone out of the crankcase.You will be astounded at what you will see in the drainpan.Go ahead and change the oil and filter.Drive it about 500 miles and repeat this using the other qt. of Rislone.When you get it cleaned out start changing your oil every 3000 miles.The reason you don't see oil on the dipstick is because the engine is gummed up the oil is trapped in the upper part of the engine.It has no quick path back to the oil pan.If you check it with the engine cold "after it sits for several hours" it will probaly check full.The noise you hear is the hydraulic lifters rattling due to lack of oil and pressure.Run it like this for long and you will need an engine.This truck probaly calls for 5w30 motor oil.I would use a good 10w30 wt. in it now and keep it changed at 3000 mile intervals.Good Luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
