Tractor Talk Discussion Board |
Re: Restoring Gauges?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on October 18, 2000 at 18:20:36 from (209.115.159.122):
In Reply to: Restoring Gauges? posted by JB on October 18, 2000 at 08:32:48:
I've found the same thing - getting that bezel off is not easy. Prying it off very carefully is the only way that seems to work. Just a small screwdriver under the lip on the outside a wee bit at a time going around and around will usually do the trick. Even then, they are pretty tight but can usually be coaxed off. After cleaning up, etc. they go back together OK. Sometimes you've got to cut a new rubber or paper gasket as a seal. Then, bend the bezel back to where it was once everything is together. You'll probably break a glass plate or two but if you've got a good collection, most glass seems to work elsewhere.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|