Tractor Talk Discussion Board |
Re: Life after oven cleaner....
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by clooney on October 17, 2000 at 15:42:10 from (207.16.59.164):
In Reply to: Life after oven cleaner.... posted by Karl in Indiana on October 17, 2000 at 11:28:29:
Karl, it's power rotary brush & elbow grease time. Anything that will easily come off the tractor you can sand blast, but on the tractor main frame & anything that is attached to the engine or transmission use a wire brush & scraper. (lately I have been using an air powered needle de-scaler on the castings especially in the corners & pockets & found it not only works good to remove paint & rust but leaves the castings looking even & rough as though they were new). I personally use a product called Rust Destroyer from "The Shop" in California...800-525-9188, it isn't cheap but does a good job of killing rust. The rust converters that I have tried haven't worked (they only convert the top layer & leave the rust underneath that will come back later) & I have had a hard time getting the paint to stick to them. I am also sold on epoxy primer but they are quite expensive & I use a fresh air supply while painting with them as they are quite toxic. When it comes to stopping rust & a good LASTING paint job you get what you pay for. This is MY opinion & I have been doing this for quite a few years, but I am sure there are other methods that work just as well so listen to all & try what you trust & feel will work, then stick with what works for YOU!
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|