Posted by Buzzman72 on June 12, 2009 at 20:05:13 from (74.129.220.44):
In Reply to: Re: us and them posted by OliverGuy on June 12, 2009 at 17:23:40:
About those "UAW workers with no education"...
That's the EMPLOYER'S FAULT, for not putting MINIMUM STANDARDS in force as part of their hiring criteria. At the UAW plant where I made frames for Ford Explorers, a high-school education was a MINIMUM to get in the door [diploma or GED was required]. THEN there were the written tests on math and verbal ability...then, after hire but while still a probationary employee, we had to go to a 5-day MIG welding school [40 hours], and had to pass the welding tests to keep our jobs. Then, once on the plant floor, we had to prove we could still do the job under assembly-line conditions, or we were OUT. LOTS of probationary employees didn't survive the 60-day probation period.
So if unqualified, uneducated employees were the norm, it was because the EMPLOYER allowed it. The plant where I worked did a pretty good job of screening out the uneducated posers and losers. Sorry the employer you refer to had LOWER STANDARDS than where I worked, but it certainly wasn't the UAW's fault. Lay the blame where in belongs...on low standards set by the EMPLOYER. The UAW plant where I worked set higher standards, and the employees got NO union representation until they survived the probation period.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
