Posted by Lanse on June 01, 2009 at 19:13:50 from (65.89.42.129):
Sorry for the sorta OT, it atleast can partain to tractors unlike some other OTs, so i guess its allright....
Ive been rolling the idea around in the back of my head for a while, and now that schools finally out i can accually persue it some. Welding seems like it would be a really useful skill for me to learn, and its something most kids dont know a thing about anyways.
Ive watched a good number of how-to videos on youtube and it doesnt look to be that hard once ya get the hang of it, but that seems to be fun part. Id really like to get good enough to do cast iron at some point....
Just from what little ive dug up online, the best i can figure is id find the most uses around here for an arc welder. The garage has both 120 and 240 volt, so im not so limited.
Classes would really hit the spot but that doesnt seem to be that much of an option...
Its not hard to track down a good used lincoln or hobart on craigslist for $100 or so... And im going to look at one tomorrow a few towns over.
Is there anything in particular to look at/for?? Wear points or anything of that nature??
My general plan...assuming one of these machines looks good enough to bring home... is to drag up a ranger full of junk from the scrap pile and figure it out through trial and error, like most things i do...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
