Posted by Don-WI on May 31, 2009 at 19:52:49 from (72.135.112.139):
Today I finished working on our gehl 920 wagon- We bought it last fall at my second cousin's estate auction for $400. It had an almost brand new apron chain in it so it was worth it for that little cost.
We used it for maybe 3 loads, when the apron cross bars caught the steel over the apron drive shaft and wrecked a chunk of the chain and the steel was trashed. We replaced the steel over the shaft, lined the floor in poly, and fixed the apron chain.
Then we also replaced the steel in the cross conveyor because that was rotten, and the end plates that hold the bearings and the adjustment for the cross conveyor were shot. We replaced a bearing on the middle beater because a peice of that fell out when we removed the beaters to work on the wagon. We also had to replace the shaft the PTO hooks up to and the bearings on that shaft, and also the sprockets on that shaft. Total investment in parts is around $700.
$438 for the parts from GEHL, $158 for the poly to line the floor, $35 for the shaft and 2 sprockets, $29 for the bearings on the shaft, $30 for the metal strapping we used to hold the poly down, I forget the other expenses, but there was random hardware etc...
All I gotta do now is get a new sprocket to drive that middle beater as I had to torch it off. I think I've got close to 40 hours in it, but hopefully it'll work for years to come now without troubles.
Tomorrow I get the 1855 ready for the chopper and pull that out.
I'll try to get pictures of it next time I'm home.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.