Posted by Jason1Pa on May 15, 2009 at 13:54:31 from (67.150.80.11):
Hello,I have a few questions about flyweel sizes or I guess I should say Flexplates (Auto Trans.) I need to replace the flexplate on a street rod of mine. I can not seem to find a flex plate with the center hole big enough to fit on/over the crankshaft. Also the the bolt holes will not line up. Question number #1. Is there a difference between a truck and a car when it comes to fleplates? How about if it is a 4 bolt main? I do not kow the year of the engine. The orginial owner had it built and knows nothing about the specs.. It was a short block engine and the car was built in 1992 so I would assume it is around that year engine. Is the flexplate something that GM would of changed much threw the years or was it pretty much a standard size? Any help would be great! thank you very much for your time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.