Tractor Talk Discussion Board |
Re: gm alternater wiring
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon Hagen on September 19, 2000 at 21:28:34 from (63.160.194.119):
In Reply to: gm alternater wiring posted by bunky on September 19, 2000 at 18:52:58:
Wire the #2 wire on the new alt to the bat terminal on the alt rear. The #1 terminal on the new alt is wired to the #4 socket on the 0ld regulator plug if the machine has an alternator light. If the machine has an amp guage the #1 alternator wire needs to connect to the regulator plug terminal that is live only when the ignition switch is on( likley #3or4 , check with a test light.) If this terminal which is hot only when the ign is on is wired to the switch ACC terminal it will work OK, but if this wire is connected to the IGN side of the switch you may need to add a diode or resistor to the wire that goes to the #1 alt terminal.If the engine stops when you turn off the IGN switch it should be OK.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|