Posted by richard from se az on May 09, 2009 at 22:24:36 from (209.203.84.163):
In Reply to: O/T ammo posted by Nancy Howell on May 09, 2009 at 05:47:05:
I'm from Se AZ. Haven't been shopping for ammo cuz I have always made it a habit to pick up a box or two of whatever caliber whenever I can. I shoot as much as time allows but I still have quite a bit. Bought Seller & Bellot 9MM back when it was $119.00 per thou. I also reload a lot. 40SW,9MM 38-357, 45ACP, 30 carbine, and a few rifle calibers. Relaxing cuz it takes my mind off of everything else.I weigh every rounds powder and use a single stage press cuz I'm never in a hurry. I recently (two weeks ago) went on a turkey hunt in New Mexico and stopped in at a gun shop in Alamogordo. He had quite a bit of hand gun ammo. I only bought some small pistol primers cuz I was down to 100. He had winchester and I think Federal. I hope this madness ends soon.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.