Don't panic.Don't put your arm in her either,will introduce more bacteria and will end up making her really sick than.If she is quiet enough to get close to,you can give it a gentle pull from outside,but not very hard,or you will cause tearing and lead to more problems.5 cc's,or ml's of oxytocin may help.Also,3 ml's of a prostroglanden will help her out too,we use Estrumate here,not sure what's available there.If it's still there 4 days from now,than it would be a good idea to consult with your vet.I've seen them disenfect them ,uterine drench with dextrose to shrink and help release the placenta too.If they do that,you will be better off treating her with penicillian for 4 days,about 40 ml's a day,maybe even 5 days.If you get a cow with metritis,she can get pretty sick,can also lead to a displaced abomasium (flipped stomache)because when they have a fever,they don't eat,which can cause a fresh cow to get a DA.Hope I didn't scare you,but you need to handle retained placenta's carefully.PD.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
