Posted by jd b puller on May 01, 2009 at 13:59:41 from (192.43.65.245):
In Reply to: giving a hog a shot posted by Gary in TX on May 01, 2009 at 06:13:14:
Roy in Ga said: (quoted from post at 10:13:14 05/01/09) well my project has turned and bit me (so to speak) I just moved my dads #450 + hog to my place and had her bread. the boar evidently had a respiratory infection. He was coughing when we unloaded him. I thought it was due to the move. Now my sow is coughing and the vet said it is a resp. infection. I have to give her a shot in her flank and have never done this before. Any suggestions or instructions to help me locate the best place in the flank. She is pretty tame as I pet her daily and when I give her a shot I would hate for her to (turn and bite me)
a 450# hog with a bucket over her head. I can't see anything going wrong with that. Rememinds me of a time I watched 3 - 250# men try to corral a hog with a 20' ladder. Pretty much the hog stuck his nose in the rungs and took off.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.