Tractor Talk Discussion Board |
Case 530 (541)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike Fitch on September 08, 2000 at 06:19:38 from (205.188.195.27):
I am close to having my sweet little Case 541 restored to like new condition, but am working on a few little details: Does anyone know where I can find two replacement instrument lamp assemblies (mine are rusted shut...i'm working to open them) that fit externally into holes in the dash (with small spring fingers on the lamp to hold in place)? They fit in a hole that is 1/2 to 5/7 inch in diameter, and are grounded by contact with metal. There is a small slit where the bulb shines through to illuminate the guages. Also, where can I find a replacement gas tank level sensor assembly? I do have the Case parts manual, but I think these parts are no longer available.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|