Posted by richardinnz on April 22, 2009 at 03:34:06 from (125.239.161.197):
In Reply to: plow problems posted by glf73 on April 21, 2009 at 16:02:39:
Furrow width too narrow in relation to depth, max depth is ussually around 60% of the furrow width. Shares too wide, when ploughing grassland, especally old stuff you need a lot narrower share than you can use in subble or other looser ground Is the plough pitched too far forward? the mouldboards will not work prperly if it is, adjust top link to suit The plough, when in work should appear level from all directions Check the disc coulter settings, you may have to run deeper than normal so the mouldboard starts to turn the furrow slice quickly, or it will lift the furrow straight up before turning it. Sometimes a bit of extra speed helps, if you are using a short board plough, which most American and Canaidian ploughs were, use tailpieces on the mouldboards. If your plough has adjustable moulboard stays these can be used to advantage.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.