Tractor Talk Discussion Board |
Re: Can't start my Farmall B
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on August 27, 2000 at 15:30:57 from (12.75.197.38):
In Reply to: Can't start my Farmall B posted by Joe Rhodes on August 27, 2000 at 14:14:49:
Joe first of all look at the top of this page where you see "another discussion forum" in the box. Highlight the arrow and you will find the Farmall board. With the valve cover off and with the #1 cylinder on compression top dead center (make sure you aren't 180 degrees out!) note the position of the rotor. Then turn the distributor so the points are just opening at this point. The distributor cap post that lines up with the rotor will be #1 followed by #3, #4, and #2. in a clockwise manner on the distributor cap. You might have installed it and the rotor is not in the approximate 2 o'clock position from factory installation. Report back with your findings on the Farmall board and welcome aboard!
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|