I've welded both cast steel and cast iron without any problems. The cast steel was on the bucket pivot on our loader. I ground it out and first laid down some 6011 in the bottom, then 7014 or 7018 on top. Been about a year now and the arm is still holding up, even after a winter of frozen manure piles, moving large chunks of concrete, rocks, and anything else the typical loader tractor gets abused for.
I've welded several cast iron things, one was the hitch clevis on our disc. Still holding solid. I veed it out all the way through, and laid multiple passes of Ni rod, chipping and peening it after every pass. I didn't have any sand or anything to stick it in to cool it as slow a it should be, but it's held very solid for 10 years now. (I was a freshman in High School welding class when I did it)
If you grind it out and chip the slag after every pass and take your time, I wouldn't be afraid of welding it at all. I've welded several other peices of cast so far, and so far they've all held up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.