Posted by Casey in Ky on April 09, 2009 at 20:10:02 from (76.8.179.60):
Ok, I went ahead and bought a Delco alt. and mounted it tonight. It's solid, but the pulley doesn't line up perfect with the others, it's off just about the width of the pulley. Will this hurt the belt or the bearings in the alternator itself? I made a rough bracket for the top mount and the bottom I just changed to one long bolt and put in a spacer.
And as far as the actual electrical hookups go, I talked it over with the guys at NAPA and I'm gonna try the swap to a Delco. None of the those guys or myself for that matter, were %100 on what wires went where on the delco. The delco has the battery connection(red wire, only one we were all certain about), and it has the two plugs right next to each other labeled r1 and f2. We assumed the bigger plug off of the back of the Lucas goes to the f2(field) plug while the smaller plug goes to the r1. Assuming the white wire is the instrument panel wire, they thought it should go to the battery connection while I think it should go to the r1 plug(if the r1 plug is the sense circuit). I'm hoping I'm making sense with all of this. Here's a couple of pics of the mount job.
Sorry for the double post, here and over on the ford board, just thought there might be some non Ford people that might have some input, Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.