Tractor Talk Discussion Board |
Clutch overhaul?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by hendrik on August 17, 2000 at 00:23:42 from (194.53.253.50):
The clutch disk of my Farmall Super A is well worn. Friction faces on flywheel and pressure plate look worn too, but healthy. The 'clutch and brake shop' I talked to say they would not only put new linings on the disk but need the whole assembly: flywheel, disk, pressure plate, thrust bearing, etc. to do a good overhaul. They would measure wear, evenness of springs, etc etc. Is it really worth it? Or is this a case of "if you are looking for trouble, you will always find it"? (I thought it was 'tractorman' who coined this phrase.) Thank you for any advice. Regards, Hendrik
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|