Tractor Talk Discussion Board |
Re: Re: Re: what would you do?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Burrhead on August 09, 2000 at 18:27:54 from (12.74.17.5):
In Reply to: Re: Re: what would you do? posted by jakee on August 09, 2000 at 18:07:01:
Where you been jakee?? Hope all's well up there. How come you rebuilt so many dorfs did'nt you know they last a life time without it?? I agree it would be hard for a valve guide to be passing oil, and it could'nt have much power with 80 psi compression. That engine is like you said so simple I would stick a set of rings and bearings in it and lap the valves and go on with it. That would be alots cheaper than spinning a bearing and have to grind the crankshaft. I have seen them n tractors start to eat up the valves if you keep running them with low compression.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|