Posted by HuskerMedic on March 30, 2009 at 09:52:38 from (76.84.177.49):
In Reply to: John Deee 4020 posted by Rick in MD on March 29, 2009 at 19:30:32:
I worked part-time for an older couple in the 1980's. They farmed 400 dryland acres, corn, soybeans, and a little wheat on occasion. They did it all with a couple Farmall M's, a 4020, and a 715 I.H. combine.
The 4020 did most of the tillage and field work, discing, field cultivating, and row crop cultivating (they were a full-tillage operation; that was the norm back then). The only thing the M's did were to pull a 4-row planter and do the mowing and occasional loader work (their cattle were gone by the time I worked for them). Spraying was hired custom.
They were not "overpowered" by any means, but were equipped well enough to get done in a timely manner. They only farmed their own ground and family owned ground so there were no landlords to impress. I knew of several people in the neighborhood who farmed less ground with more iron. They were definitely one of the lowest "low cost" producers around, but usually had some of the best looking corn around.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.