Posted by ScottyHOMEy on March 29, 2009 at 19:41:55 from (71.241.194.27):
In Reply to: colters posted by ford-s on March 29, 2009 at 18:17:21:
The share at the bottom of the moldboard is there to make the horizontal cut at the bottom of the furrow and maybe a few inches up. The coulter runs ahead of the tip of the share to slice the soil vertically. That gives the moldboard, which doesn't have a cutting edge of its own, a chunk of soil that it can then turn over. If you tried to pull a plow that was designed with coulters without them, it would be a lot harder to steer, pull a lot harder than it should, and you'd have a ragged edge from the moldboard having to beat it's way through instead of just doing its job, which is simply to turn the nicely cut soil over.
Plows without coulters have what are called shins, which are basically shares on the leading edge of the moldboard instead of on the bottom edge like regular shares. On those the shin does the same cutting that a coulter would, so that by the time the moldboard gets to the cut, it only has to turn it over.
So clean your plow up good to see what you have. If you have only a share bolted to the bottom of the moldboard and no provision to bolt a shin onto the leading edge, then you are missing your coulters. If, in addition to the share on the bottom, you have another piece bolted to the leading edge of the moldboard, that would be the shin and you should be good to go.
Gist of the whole thing is that shares, shins and coulters are made to cut, and moldboards are for turning. Ideally, you can break or wear out the cutting edges without having to replace the moldboard.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.