Tractor Talk Discussion Board |
Re: STUCK Engine....and I mean STUCK
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Burrhead on August 02, 2000 at 20:34:49 from (12.74.59.43):
In Reply to: STUCK Engine....and I mean STUCK posted by Mark Sanders on August 02, 2000 at 18:24:34:
When we used that same engine on sawmills and to pull gristmills sometimes they would set for 2-3 years outside in the weather with just the carb covered up. They would sometimes be locked up when we went to use the mill again. All we would do is pour the cylinders all completely full of a mix of 1/2 clean motor oil and 1/2 diesel and let it set a few days, then take a large screw driver and start doing like Ken said about turning the engine at the flywheel. Try to roll it one way then the other. When the fuel and oil mix gets down beside all the pistons it will break the cylinder's top rust out as it turns. I would take off the valve cover and be sure that none of the valves are stuck open and shut. If one is stuck open or shut it will warp the stem, and you'll end up pulling the head anyways. .
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|