If the compressor is currently being operated with a 25HP motor. Then the compressor only requires 25-27.5 HP to run steady state. Where the confusion arises is that a 25HP electric motor can make 50-60HP for brief periods of time. While these brief demands can be handled with the electric motor. These overloads will bring a 25HP gas or diesel to a quick stall. Hence a 40Hp minimum diesel engine with good torque rise is required to replace a 25HP electric motor. This will handle a brief torque demands a "50HP" peak load requires. A 40-50HP turbo diesel will loaf along at 25HP burning less fuel than a 50HP natural aspirated diesel. The turbo engine doesn't pump extra air when it isn't required. Being it's a reciprocating compressor that is always spinning at 100% speed. There is no real surge when the unloaded calls for air. Compared to rolling a reciprocating compressor from 0 to full rated rpms. 40HP is lots and 50HP is wasting fuel. A 25HP diesel running a max output with a wee trace of black in the exhaust. Will burn less fuel than a 50HP diesel on the same 25HP load. Ask jdemaris to backup the data.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
