Well, you can come out to our farm and help wrench on stuff to get it ready to go. I Took the front axel off our 1855 yesterday to rebush the pivot pin and the back support for the wishbone on the axel. The pin on the wishbone was worn so I had to weld it up and use an angle grinder on it because it's nothing that'd be practical to machine.
Now after I got it back on today, I decided that the bushings where the spindles go in the tubes are shot so I should replace those also. I pulled the spindles out and they're worn too. I'll weld those up and turn them back down at work. Might have to take the axel back off to replace the bushings in the spindle tubes though. Atleast the lower ones.....
I still got a few other projects I need to do also. Gotta change the oil on my 1600 and dad's 285, and then start putting duals on the 1855 and 285. Couple flat tires on this & that, like our disk that we don't use too often, our Fox chopper with a 24" implement tire, our gravity box, and anything else that I haven't found yet.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
