Tractor Talk Discussion Board |
Re: 460 HYDRAULICS WEAK?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan from PA on July 21, 2000 at 19:19:02 from (141.151.152.242):
In Reply to: 460 HYDRAULICS WEAK? posted by JOEL on July 21, 2000 at 11:15:41:
I would check that pressure with a gauge. Maybe your relief valve needs adjusting, or a pump needs rebuilding. Like was mentioned, cyls of larger dia will be the easiest and cheapest method to get more lift, but at the expense of cycle time. If you're up against your relief valve setting, a boost pump will do nothing for you. Increasing the pressure could bring a whole host of problems, some of them dangerous. I would be leery of modifying a machine like this beyond its design specs. My stuff seems to fall apart fast enough without any additional help from me. Consider making smaller bales. An extra trip or two beats a broken loader or tractor. Bales are harder to lift anyway, because they are usually further from the pivot points of the loader arms, and therefore require more leverage. Also, posts are much easier to read with proper use of caps. :)
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|