To add some more, The guy always uses a GM cam break in additive in the oil. I originally told him I wanted to go ahead and put a roller cam in and he said those roller kits for street engines don't hold up well. I think he means the kits for putting a roller cam in a block that was made for flat tappets. He said the rollers can break and then you have a big problem. So we are just going with a flat tappet cam. This guy had a 1st place, for 6 years running NHRA small block powered drag car years ago. I just hope this one does ok. It could be possible that I had it preloaded just a tad bit to tight, but certainly not by much as that was done while the intake was off and the engine rotated to valve closed position and lifters pre oiled or loaded. He said the engine bearings all had a 1978 date code on them so it did have some work done to it in the past but it had all GM parts in it when I took it apart last year. At least as far as cam and timing gears go. Last week when I was reaserching croller cams, I tried to call Crane and they are for sure closed as well as the Mikronite parent company. Guy at Summitt racing said he thinks Comp cams may pick them up in the near future. Some guys on an automotive message board said they went past the Crane shops in Daytona and there was just one car in the parking lot last week. Another guy posted the there were 4 cars in Mikronites parking lot in New Jersey. Sign of the times!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
